Developing a prototype micro hot embossing setup
This paper discusses the development of a prototype of micro hot embossing setup. It included microtool, heating jig, temperature controller, cooling system, etc. The total cost was about few thousand USD. All these components were used with the help of a numerical control (NC) milling machine. The...
| Main Authors: | , , |
|---|---|
| Format: | Conference or Workshop Item |
| Language: | English |
| Published: |
2005
|
| Subjects: | |
| Online Access: | http://irep.iium.edu.my/27181/ http://irep.iium.edu.my/27181/1/061_IMEC_2005_MS39_IEB_Dhaka_34-39.pdf |