Temperature distribution in copper electrode during electrical discharge machining process
This paper reports on a new method used to estimate the spark radius in the gap during electrical discharge machining (EDM). This method combines the heat flux and energy equations of the copper electrode. The energy partition between workpiece and electrode (tool) due to EDM process was estimated u...
Main Authors: | Abdulkareem, Suleiman, Khan, Ahsan Ali, Shah, Qasim Hussain, Konneh, Mohamed |
---|---|
Format: | Article |
Language: | English English |
Published: |
Penerbit UHTM
2017
|
Subjects: | |
Online Access: | http://irep.iium.edu.my/56409/ http://irep.iium.edu.my/56409/ http://irep.iium.edu.my/56409/ http://irep.iium.edu.my/56409/1/Temperature%20distribution.pdf http://irep.iium.edu.my/56409/7/56409_Temperature%20distribution%20in%20copper%20electrode_SCOPUS.pdf |
Similar Items
-
Reducing electrode wear ratio using cryogenic cooling
during electrical discharge machining
by: Abdulkareem, Suleiman, et al.
Published: (2009) -
Influence of electrode profiles on electrical discharge machining of titanium
by: Zain, Zakaria Mohd, et al.
Published: (2011) -
Modeling of EDM Process parameters for Machining Stainless Steel using Copper Electrodes
by: Khan, Ahsan Ali, et al.
Published: (2008) -
Tool wear rate during electrical discharge machining (EDM) with eccentric electrode
by: Khan, Ahsan Ali, et al.
Published: (2011) -
Influence of electrode cooling on material migration among the electrodes during EDM of titanium alloy
by: Abdulkareem, Suleiman, et al.
Published: (2011)