Design and analysis of 1-to-4 Wilkinson power divider for antenna array feeding network
In this paper, A Novel 1 to 4 modified Wilkinson power divider operating over the frequency range of (3 GHz to 8 GHz) is proposed. The design perception of the proposed divider based on two different stages and printed on FR4 (Epoxy laminate material) with the thickness of 1.57mm and ϵr =4.3 re...
| Main Authors: | , , , , , |
|---|---|
| Format: | Conference or Workshop Item |
| Language: | English English |
| Published: |
IEEE
2018
|
| Subjects: | |
| Online Access: | http://irep.iium.edu.my/64226/ http://irep.iium.edu.my/64226/ http://irep.iium.edu.my/64226/ http://irep.iium.edu.my/64226/7/64226%20Design%20and%20Analysis.pdf http://irep.iium.edu.my/64226/13/64226_Design%20and%20analysis%20of%201-to-4%20wilkinson%20power%20divider_SCOPUS%20CONF.pdf |
| Summary: | In this paper, A Novel 1 to 4 modified Wilkinson
power divider operating over the frequency range of (3
GHz to 8 GHz) is proposed. The design perception of the
proposed divider based on two different stages and printed
on FR4 (Epoxy laminate material) with the thickness of
1.57mm and ϵr =4.3 respectively. The modified design of
this power divider including curved corners instead of the
sharp edges and some modification in the length of
matching stubs. In addition, this paper contain the power
divider with equal power split at all ports, reasonable
insertion loss, acceptable return loss below -10 dB, good
impedance matching at all ports and satisfactory isolation
performance has been obtained over the mentioned
frequency range. The design concept and optimization
development is practicable through CST simulation
software. |
|---|