Veneer recovery and properties of plywood made from coconut trunk (cocos nucifera) / Yanti Abdul Kadir
A study was undertaken to evaluate the physical and mechanical properties of plywood made from coconut veneers bonded with urea formaldehyde resin. Five coconut trunks were obtained from a coconut plantation in Bagan Datoh, Hutan Melintang, Perak Trunks were cut into 165 em billets of different port...
| Main Author: | |
|---|---|
| Format: | Thesis |
| Language: | English |
| Published: |
2015
|
| Subjects: | |
| Online Access: | http://ir.uitm.edu.my/id/eprint/15289/ http://ir.uitm.edu.my/id/eprint/15289/1/TM_YANTI%20ABDUL%20KADIR%20AS%2015_5.pdf |
| Summary: | A study was undertaken to evaluate the physical and mechanical properties of plywood made from coconut veneers bonded with urea formaldehyde resin. Five coconut trunks were obtained from a coconut plantation in Bagan Datoh, Hutan Melintang, Perak Trunks were cut into 165 em billets of different portions, bottom,
middle and top from which veneers were obtained. The specific objectives of the study were, firstly, to evaluate veneer recovery percentage from peeling process, secondly, to evaluate physical properties of plywood made of coconut trunk. The portions were peeled to get the inner and the outer veneers. The study showed that the veneer recovery rate of the coconut trunks decreased from the bottom to the top portion of the stem. However, the difference of the recovery rate between each portion was not significant. The mean values of the green veneer recovery for the bottom , the middle, and the top were 53.71%, 48.41% and 47.00% respectively. The veneer recovery rate was also evaluated through different diameters of coconut trunks. The diameter classes chosen for the study were 23.1cm-25cm (class 1), 25.1cm-28cm (class 2), and 28.1cm-33cm (class 3). Veneer recover rate showed insignificant differences in height level and diameter classes. There was insignificant different in Me % even though inner part of trunks possessed higher Me % compared to the outer part. By comparing the Me % between bottom, middle and top parts, it seemed that higher Me % values were recorded from the top part compared to the middle and bottom parts. As for density study of the veneers, it could be seen that inner veneers
had lower density from that of the outer veneers. The outer part showed higher density due to the concentration of vascular bundles present in the region. The bottom part of the trunk exhibited higher density value compared to the middle and top parts.Pressing pressure and time were also evaluated. The study revealed that the best pressing pressure and time to manufacture coconut-based plywoods were 500psi and 10 minutes respectively. The evaluation was made based on the physical and
mechanical properties of the plywoods made at three different pressing pressure and time. The pressing pressure and time were used to fabricate more coconut-based plywoods for further physical and mechanical testing. This time, only density test was
included for physical testing. Three types of mechanical testing were conducted on the plywoodc made from coconut i.e modulus of rupture (MOR) (BS EN 310:1993), modulus of elasticity (MOE) (BS EN 310: 1993), screw withdrawal (SW) CBS EN 699:
Part 1:1989) and shear strength (88) (BS EN 314-1:1993). The physical and mechanical examinations showed that the plywoods made of the determined pressing pressure and time was suitable to produce plywoods which has strength that surpassed
the standard requirement values of each testing. |
|---|