The effects of niobium addition on mechanical and physical properties of austempered ductile iron / Siti Khadijah Alias
Austempered Ductile Iron (ADI) is merging as one of potential material in many engineering applications especially in automotives components and heavy machineries applications. The development of Austempered Ductile Iron is a significant necessity, as this material possessed superior properties,...
| Main Author: | |
|---|---|
| Format: | Thesis |
| Language: | English |
| Published: |
2010
|
| Subjects: | |
| Online Access: | http://ir.uitm.edu.my/id/eprint/4268/ http://ir.uitm.edu.my/id/eprint/4268/1/TM_SITI%20KHADIJAH%20ALIAS%20EM%2010_5%201.pdf |
| Summary: | Austempered Ductile Iron (ADI) is merging as one of potential material in many engineering
applications especially in automotives components and heavy machineries applications. The
development of Austempered Ductile Iron is a significant necessity, as this material possessed
superior properties, high castability, and lower cost compared to steel. This thesis investigates
the effect of Niobium element addition on the mechanical and physical properties of alloyed
ductile iron before and after austempering process. The constitution of ductile iron (DI) and
two newly developed materials which were 0.5wt % Niobium alloyed ductile iron (0.5wt %
Nb-DI), and 2wt % Niobium alloyed ductile iron (2wt % Nb-DI) were made through Y block
(300mm x Ø25mm) CO2 sand casting. Samples were then austenitized at 900 ºC for 1 hour
before austempered at 350 ºC at 3 different holding times which were 1 hour, 2 hours and 3
hours consequently. Mechanical and physical properties of as cast and austempered samples
with different holding time were evaluated through hardness, impact (ASTM E23), tensile
(TS 138 EN1002-1) and density test. Microstructure observations which was obtained
through Olympus B X 41M microscope and Scanning Electron Microscopy (SEM)
observation were also done after 2% Nital chemical etched. Microstructure observations
revealed that ductile iron possessed the structures of graphite nodules surrounded by island of
ferrite and pearlite and addition of Niobium had promoted graphite nodules and Niobium
Carbide (NbC) in polygonal form dispersed in matrix of pearlite. The experimental results
explicitly indicated samples of 2wt % Nb-ADI (1 hr) gives the optimum tensile strength and
impact toughness properties among all types of samples which associated with the fine
bainitic and retained austenite matrix, in coupled with the presence of Niobium Carbide in the
material structure. It was also demonstrated that the tensile strength and impact toughness
properties of Nb alloyed austempered ductile iron decreased corresponding to longer
austempering time as coarser retained austenite and bainitic structure were observed. In
opposition to that, austempering process at 350°C for 3 hours holding times gives maximum
obtainable hardness properties which is due to formation of martensitic and bainitic structure
due to longer holding time. The densities of alloyed ductile iron and austempered ductile iron
however had only slightly variations as compared to conventional ductile iron and
austempered ductile iron with approximately 1.94% differences.
Keywords: Mechanical Properties, Sand Casting, Austempered Ductile Iron, Cast Iron,
Niobium |
|---|