Characterization of Plasticized CMC-NH4BR Based Biopolymer Electrolyte and Electrochemical Studies on the Solid-State Batteries
Much research has been devoted to the preparation of solid polymer electrolytes made of various materials. Some of the wellknown are synthetic polymer materials (petroleum resources) but these polymers are high in cost and the depletion of petroleum resources coupled with increasing environmental...
| Main Authors: | , |
|---|---|
| Format: | Conference or Workshop Item |
| Language: | English |
| Published: |
2015
|
| Subjects: | |
| Online Access: | http://umpir.ump.edu.my/id/eprint/11164/ http://umpir.ump.edu.my/id/eprint/11164/1/Characterization%20Of%20Plasticized%20Cmc-Nh4br%20Based%20Biopolymer%20Electrolyte%20And%20Electrochemical%20Studies%20On%20The%20Solid-State%20Batteries.pdf |
| Summary: | Much research has been devoted to the preparation of solid polymer electrolytes made of various materials. Some of the wellknown
are synthetic polymer materials (petroleum resources) but these polymers are high in cost and the depletion of petroleum
resources coupled with increasing environmental regulation. For these reasons, a lot of effort has been made to develop the
electrolytes using natural biopolymer materials. The increasing interest in green energy storage materials for electrochemical
devices with the development of polymer as electrolytes candidate has attracted great attention recently. It can offer a number
of high-value opportunities, provided that lower costs can be obtained besides environmental friendly. Due to this matter, the
development of plasticized biodegradable polymer electrolytes (BPEs) has been accomplished in this work by incorporating
various composition of EC with carboxy methylcellulose doped NH4Br via solution casting method. The plasticized polymer–
salt complex formation and ionic conduction of BPEs have been analyzed through infrared spectroscopy and impedance
measurement. Plasticization using EC in BPEs system helps the enhancement of NH4Br dissociation and therefore increases the
protonation process in the system. The highest ionic conductivity obtained for CMC−NH4Br containing with 25 wt. % NH4Br
was achieved at 1.12 x 10-4
S cm-1
and enhanced to 3.31 x 10-3
S cm-1 with addition of EC. The conductivity-temperature for
BPEs system obeys the Arrhenius relation where the ionic conductivity increases with temperature. The electrochemical cell
were fabricated with the configuration of Zn + ZnSO4.7H2O | BPEs system | MnO2 for the highest conductivity and produced a
maximum open circuit voltage of 1.48 V at ambient temperature and showed good rechargeability. |
|---|