CFD study of the effect of SWM feed spacer geometry on mass transfer enhancement driven by forced transient slip velocity
Recent studies have shown that the interactions between forced transient flow and eddy inducers (i.e. spacers) in spiral wound membrane modules results in significant mass transfer enhancement and reduction in concentration polarisation (CP). This paper uses CFD to investigate the effect of varying...
| Main Authors: | , , |
|---|---|
| Format: | Article |
| Language: | English |
| Published: |
Elsevier Ltd
2019
|
| Subjects: | |
| Online Access: | http://umpir.ump.edu.my/id/eprint/27167/ http://umpir.ump.edu.my/id/eprint/27167/ http://umpir.ump.edu.my/id/eprint/27167/ http://umpir.ump.edu.my/id/eprint/27167/1/CFD%20study%20of%20the%20effect%20of%20SWM%20feed%20spacer%20geometry.pdf |
| Summary: | Recent studies have shown that the interactions between forced transient flow and eddy inducers (i.e. spacers) in spiral wound membrane modules results in significant mass transfer enhancement and reduction in concentration polarisation (CP). This paper uses CFD to investigate the effect of varying the spacer geometric parameters on the resonant frequency for an unsteady forced-slip, as well as the resulting permeate flux enhancement, for a 2D zig-zag spacer. The analysis shows that the resonant frequency is significantly affected by the interaction of the shear layer with successive downstream spacers. The effectiveness of forced-slip reaches a peak (up to 15.6% flux increase) for a spacer size in the range of 0.5<df/hch<0.6 because of the trade-off between mixing-induced forced-slip and the CP modulus. In addition, vortex shedding is suppressed for smaller spacer sizes (df/hch≤0.4), because viscous forces dominate over convective forces due to a smaller filament Reynolds number. As the distance between filaments is increased, the increase in flux due to forced-slip is greater (up to 31.5%), albeit the actual flux decreases because the boundary layer is more developed. These results also reinforce the finding that forced-slip is more efficient for spacer designs with poor mixing (i.e. high CP). |
|---|