Experimental analysis of tool wear when drilling carbon fibre composite (CFC) without cutting fluid, with cutting fluid and with a pre-cryogenically cooled tool

by Dahnel, Aishah Najiah, Barnes, Stuart, Bhudwannachai, Pipat
Published 2013

Drilling of carbon fibre composites: a review

by Dahnel, Aishah Najiah, Barnes, Stuart, Bhudwannachai, Pipat
Published 2014

The effect of varying cutting speeds on tool wear during conventional and Ultrasonic Assisted Drilling (UAD) of Carbon Fibre Composite (CFC) and titanium alloy stacks

by Dahnel, Aishah Najiah, Ascroft, Helen, Barnes, Stuart
Published 2016

Analysis of tool wear and hole quality during Ultrasonic Assisted Drilling (UAD) of Carbon Fibre Composite (CFC)/titanium alloy (Ti6Al4V) stacks

by Dahnel, Aishah Najiah, Barnes, Stuart, Ascroft, Helen, Gloger, Maximilian
Published 2015

Study of cutting forces and surface roughness in milling of Carbon Fibre Composite (CFC) with conventional and pressurized CO2 cutting fluids

by Dahnel, Aishah Najiah, Barnes, Stuart, Kibbler, Christopher, Ascroft, Helen
Published 2015

A metrological inspection method using micro-CT for the analysis of drilled holes in CFRP and titanium stacks

by Kourra, Nadia, Warnett, Jason, Attridge, Alex, Dahnel, Aishah Najiah, Ascroft, Helen, Barnes, Stuart, Williams, Mark,
Published 2017