-
1by Ginta, Turnad Lenggo, Amin, A. K. M. Nurul, Lajis, Mohd Amri, Karim, A.N. Mustafizul, Che Daud, Mohd Radzi“… alloy Ti-6Al-4V bar was used as the workpiece. Machining was performed with a 20 mm diameter end-mill…”
Published 2009
Get full text
Get full text
Get full text
-
2by Ginta , Turnad L., Amin, A. K. M. Nurul, Lajis, M. A., Karim, A.N. Mustafizul, Mohd Radzi, H.C.D.“… alloy Ti-6Al-4V bar was used as the workpiece. Machining was performed with a 20 mm diameter end-mill…”
Published 2009
Get full text
Get full text
-
3by Amin, A. K. M. Nurul, Arif, Muammer Din, Subir, Siti Aminatuzzuhriyah B. Haji, Abdullah, Fawaz Mohsen“… of (AISI 304) stainless steel by using permanent bar magnets. Reduction in chatter and corresponding tool…”
Published 2015
Get full text
Get full text
Get full text
Get full text
-
4“… studies have been carried out. In this research, two permanent ferrite bar magnets of 1500 Gauss strength…”
Get full text
Get full text
Get full text
Get full text
Get full text
-
5by Hossain, Muhammad Ishtiyaq, Amin, A. K. M. Nurul, Patwari, Muhammed Anayet Ullah, Karim, A.“… ZPS, Model: MCFV 1060 with quarter immersion cutting. Titanium based alloy Ti-6Al-4V bar was used…”
Published 2008
Get full text
Get full text
Get full text
-
6“… with full immersion cutting. Titanium alloy Ti-6Al-4V bar was used as the workpiece. Machining was performed…”
Get full text
Get full text
Get full text
Get full text
-
7“… for holding the permanent magnet bars, used in suppressing the vibration amplitudes. DASY Lab 5.6 was used…”
Get full text
Get full text
Get full text
Get full text
-
8“… bars (dimensions: 1″x6″x3″) located at either side of the cutting tool and maintaining a suitable…”
Get full text
Get full text
Get full text